| ??? 03/31/09 08:59 Read: times |
#164044 - Put load on HCT output Responding to: ???'s previous message |
You can check that the HCT (not connected) can drive the output low. But try to connect a 10k resistor from the HCT output to VCC and see if the HCT can still draw the output low. Maybe the HCT chip has a problem so that it can't sink any current. Maybe even a problem with VCC or GND to the HCT chip. |
| Topic | Author | Date |
| Pulling to 0 | 01/01/70 00:00 | |
| chips | 01/01/70 00:00 | |
| 89C450 | 01/01/70 00:00 | |
| Set a pin as input | 01/01/70 00:00 | |
| Port pin as an input | 01/01/70 00:00 | |
| Put load on HCT output | 01/01/70 00:00 | |
| Checking | 01/01/70 00:00 | |
| I see what you want to do there ... but ... | 01/01/70 00:00 | |
| so check 74hc165 with resistive load only | 01/01/70 00:00 | |
| It's not uncommon... | 01/01/70 00:00 | |
| I know that some use antiques, but ... | 01/01/70 00:00 | |
| Do we mean the same? | 01/01/70 00:00 | |
| I asid 'modern', not Arghmel | 01/01/70 00:00 | |
| Come on, Erik.... | 01/01/70 00:00 | |
| now let me get this straight ... | 01/01/70 00:00 | |
| one thing I always do ... | 01/01/70 00:00 | |
| Shame on me! | 01/01/70 00:00 | |
| Oops! | 01/01/70 00:00 | |
| Been there, done that | 01/01/70 00:00 | |
IO expansion | 01/01/70 00:00 |